Administrator Guide

NOTE: The multicast-bandwidth option is not supported on queue
ingress. If you attempt to use the multicast-bandwidth option, the
following reject error message is generated:
% Error:Bandwidth-percent
is not allowed for ingress multicast.
rate-police
Specify the policing functionality on incoming traffic.
Z9000
Syntax
rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). Make the following value a multiple of 64.
The range is from 0 to 40000000. The default granularity is
Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 100.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
The default is the same as designated for
committed-rate.
Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate.
Granularity for committed-rate and peak-rate is Mbps unless you use the kbps
option.
Command
Modes
QOS-POLICY-IN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
The default burst size is 100Kb. If a different value is required, you must configure
the burst size to the required value.
1248
Quality of Service (QoS)