Administrator Guide

show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
Z9000
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format
to view RIP information on that network only. If you enter an
IP address, also enter a mask for that IP address.
mask (OPTIONAL) Specify a mask, in /network format, for the IP
address.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show ip rip database command shown in the
following example.
Field Description
Total number of
routes in RIP
database
Displays the number of RIP routes stored in the RIP
database.
100.10.10.0/24
directly
connected
Lists the routes directly connected.
150.100.0.0
redistributed
Lists the routes learned through redistribution.
209.9.16.0/24... Lists the routes and the sources advertising those routes.
1302
Routing Information Protocol (RIP)