Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Related
Commands
line — applies an authentication method list to the designated terminal lines.
ip access-list standard — names (or selects) a standard access list to filter based on
the IP address.
ip access-list extended — names (or selects) an extended access list based on the
IP addresses or protocols.
enable password
Change the password for the enable command.
Z9000
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type]
password [level level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the
level of access. The range is from 1 to 15.
encryption-
type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text
string must be a password that was already encrypted by a
Dell Networking router.
Use this parameter only with a password that you copied
from the show running-config file of another Dell
Networking router.
password Enter a text string, up to 32 characters long, as the clear text
password.
Defaults No password is configured. level = 15.
Security
1357