Administrator Guide

Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
To control access to command modes, use this command to define a password for
a level and use the privilege level (CONFIGURATION mode) command.
Passwords must meet the following criteria:
• Start with a letter, not a number.
• Passwords can have a regular expression as the password. To create a
password with a regular expression in it, use CNTL + v prior to entering regular
expression. For example, to create the password abcd]e, you type “abcd CNTL
v ]e”. When the password is created, you do not use the CNTL + v key
combination and enter “abcd]e”.
NOTE: The question mark (?) and the tilde (~) are not supported characters.
Related
Commands
show running-config — views the current configuration.
privilege level (CONFIGURATION mode) — controls access to the command
modes within the switch.
enable restricted
Allows Dell Networking technical support to access restricted commands.
Z9000
Syntax
enable restricted [encryption-type] password
To disallow access to restricted commands, use the no enable restricted
command.
1358
Security