Administrator Guide

To return to the default setting, use the radius-server retransmit 3
command.
Parameters
retries Enter a number of attempts that FTOS tries to locate a
RADIUS server. The range is from zero (0) to 100. The default
is 3 retries.
Defaults 3 retries
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Related
Commands
radius-server host — configures a RADIUS host.
radius-server timeout
To reply to a request, configure the amount of time the RADIUS client (the switch) waits for a RADIUS
host server .
Z9000
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds Enter the number of seconds between an unsuccessful
attempt and the Dell Networking OS times out. The range is
from zero (0) to 1000 seconds. The default is 5 seconds.
Defaults 5 seconds
1378
Security