Administrator Guide

• If 802.1X is disabled on the port, it is returned to the configured access VLAN.
• When the port is in the Force Authorized, Force Unauthorized, or Shutdown state, it is placed in the
configured access VLAN.
• If an 802.1X port is authenticated and put in the RADIUS server assigned VLAN, any change to the port
access VLAN configuration does not take effect.
• The 802.1X with VLAN assignment feature is not supported on trunk ports, dynamic ports, or with
dynamic-access port assignment through a VLAN membership.
dot1x authentication (Configuration)
Enable dot1x globally; dot1x must be enabled both globally and at the interface level.
Z9000
Syntax
dot1x authentication
To disable dot1x on globally, use the no dot1x authentication command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
Related
Commands
dot1x authentication (Interface) — enables dot1x on an interface.
dot1x authentication (Interface)
Enable dot1x on an interface; dot1x must be enabled both globally and at the interface level.
Z9000
Syntax
dot1x authentication
To disable dot1x on an interface, use the no dot1x authentication command.
Defaults Disabled.
1388
Security