Administrator Guide

Parameters
interface Enter one of the following interfaces and slot/port
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
in | out | both Enter the keyword in, out, or both to debug incoming
interfaces, outgoing interfaces, or both incoming and
outgoing interfaces.
vlan vlan-id Enter the keyword vlan then the VLAN ID. The range is from
1 to 4094.
count value Enter the keyword count then the number of debug
outputs. The range is from 1 to 100.
Defaults Debug disabled.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series, E-Series, and E-Series ExaScale.
Version 7.4.1.0 Introduced
1436
Service Provider Bridging