Administrator Guide

protocol-tunnel destination-mac
Overwrite the BPDU destination MAC address with a specific value.
Z-Series
Syntax
protocol-tunnel destination-mac xstp address
Parameters
stp Change the default destination MAC address used for L2PT
to another value.
Defaults The default destination MAC is 01:01:e8:00:00:00.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series, and S-Series.
Version 7.4.1.0 Introduced
Usage
Information
When you enable VLAN-Stacking, no protocol packets are tunneled.
Related
Command
show protocol-tunnel — displays tunneling information for all VLANs.
protocol-tunnel enable
Enable protocol tunneling globally on the system.
Z-Series
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Defaults Disabled.
1438
Service Provider Bridging