Administrator Guide

sflow enable (Global)
Enable sFlow globally.
Z-Series
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
sFlow is disabled by default. In addition to this command, sFlow needs to be enable
on individual interfaces where sFlow sampling is desired.
Related
Commands
sflow enable (Interface) — enables sFlow on interfaces.
sflow enable (Interface)
Enable sFlow on interfaces.
Z-Series
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
sFlow
1445