Administrator Guide

Dell#show running-config interface tengigabitethernet 0/0
!
interface TenGigabitEthernet 0/0
no ip address
sflow enable
sflow sample-rate 256
no shutdown
show sflow linecard
Display the sFlow information on a line card.
Z-Series
Syntax
show sflow linecard {slot number}
Parameters
slot number (OPTIONAL) Enter a slot number to view information on the
line card in that slot.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
The dropEvent counter (sFlow samples dropped due to sub-sampling) shown in
the following example below always displays a value of zero.
Example
Dell#show sflow linecard 1
Linecard 1
Samples rcvd from h/w :165
Samples dropped for sub-sampling :0
Total UDP packets exported :0
UDP packets exported via RPM :77
sFlow
1453