Administrator Guide

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
To enable this snmp-server trap-source command, configure an IP address
on the interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address udp-port
port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-
password] [priv {des56 | aes128} priv password] [access access-
list-name | ipv6 access-list-name | access-list-name ipv6
access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name
{group_name remote ip-address udp-port port-number} [1 | 2c |
3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56 |
aes128} priv password] [access access-list-name | ipv6 access-
list-name
| access-list-name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on
the host that connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of
the group. The following groups are created for mapping to
read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro
permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-
address
Enter the keywords udp-port then the user datagram
protocol (UDP) port number on the remote device. The
range is from 0 to 65535. The default is 162.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram
Protocol) port number on the remote device. The range is
from 0 to 65535. The default is
162.
1474
Simple Network Management Protocol (SNMP) and Syslog