Administrator Guide

access-list-
name ipv6
access-list-
name
(Optional) Enter both an IPv4 and IPv6 access list name.
Defaults As above.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6.
(0.0)
Added aes 128 encryption algorithm parameter.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
NOTE: For IPv6 ACLs, only IPv6 and UDP types are valid for SNMP. TCP and
ICMP rules are not valid for SNMP. In IPv6 ACLs port rules are not valid for
SNMP.
No default values exist for authentication or privacy algorithms and no default
password exists. If you forget a password, you cannot recover it; the user must be
reconfigured. You can specify either a plain-text password or an encrypted cypher-
text password. In either case, the password is stored in the configuration in an
encrypted form and displayed as encrypted in the show running-config
command.
If you have an encrypted password, you can specify the encrypted string instead of
the plain-text password. The following command is an Example of how to specify
the command with an encrypted string.
NOTE: The number of configurable users is limited to 16.
1476
Simple Network Management Protocol (SNMP) and Syslog