Administrator Guide

Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
virtual-ip
Configure a virtual IP address for the active management interface. You can configure virtual addresses
both for IPv4 and IPv6 independently.
Z9000
Syntax
virtual-ip {ipv4-address | ipv6-address}
To return to the default, use the no virtual-ip {ipv4-address | ipv6-
address} command.
Parameters
ipv4-address Enter the IP address of the active management interface in a
dotted decimal format (A.B.C.D.).
ipv6-address Enter an IPv6 address of the active management interface, in
the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000
Version
8.3.19.0
Introduced on the S4820T.
148
Control and Monitoring