Administrator Guide

Version
8.3.12.0
Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
You can configure both IPv4 and IPv6 virtual addresses simultaneously, but only
one of each. Each time this command is issued, it replaces the previously
configured address of the same family, IPv4 or IPv6. The no virtual-ip
command takes an address/prefix-length argument, so that the desired address
only is removed. If you enter the no virtual-ip command without any specified
address, then both IPv4 and IPv6 virtual addresses are removed.
Related
Commands
ip address — assigns a primary and secondary IP address to the interface.
write
Copy the current configuration to either the startup-configuration file or the terminal.
Z9000
Syntax
write {memory | terminal}
Parameters
memory Enter the keyword memory to copy the current running
configuration to the startup configuration file. This
command is similar to the copy running-config
startup-config
command.
terminal Enter the keyword terminal to copy the current running
configuration to the terminal. This command is similar to the
show running-config command.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Control and Monitoring
149