Administrator Guide

Parameters
level Indicate a value from 0 to 7 or enter one of the following
equivalent words: emergencies, alerts, critical,
errors, warnings, notifications, informational, or
debugging. The default is 4 or warnings.
Defaults warnings or 4
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
When you configure the snmp-server trap-source command, the system
messages logged to the history table are also sent to the SNMP network
management station.
Related
Commands
show logging — displays information logged to the history buffer.
logging history size
Specify the number of messages stored in the Dell Networking logging history table.
Z-Series
Syntax
logging history size size
To return to the default values, use the no logging history size command.
Parameters
size Indicate a value as the number of messages to be stored.
The range is from 0 to 500. The default is 1 message.
Defaults 1 message
Simple Network Management Protocol (SNMP) and Syslog
1491