Administrator Guide

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router.
By configuring the logging source-interface command, the Syslog packets
contain the IP address of the interface configured.
Related
Commands
logging — enables logging to the Syslog server.
logging synchronous
Synchronize unsolicited messages and Dell Networking OS output.
Z-Series
Syntax
logging synchronous [level level | all] [limit number-of-
buffers]
To disable message synchronization, use the no logging synchronous [level
level | all] [limit number-of-buffers] command.
Parameters
all Enter the keyword all to ensure that all levels are printed
asynchronously.
level level Enter the keyword level then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
Simple Network Management Protocol (SNMP) and Syslog
1495