Administrator Guide

50
Stacking
All commands in this chapter are specific to the Dell Networking operating software on the Z9000
platform.
The commands are always available and operational, whether the S-Series has a stacking module
inserted. You can use the commands to pre-configure a switch, so that the configuration settings are
invoked when the switch is attached to other S-Series units.
For information about using the S-Series stacking feature, refer to the “Stacking S-Series Switches”
chapter in the Dell Networking OS Configuration Guide.
The Dell Networking OS commands for data center bridging features include 802.1Qbb priority-based
flow control (PFC), 802.1Qaz enhanced transmission selection (ETS), and the data center bridging
exchange (DCBX) protocol.
redundancy disable-auto-reboot
Prevent the S-Series stack management unit, stack member unit, and standby unit from rebooting if they
fail.
Z9000
Syntax
redundancy disable-auto-reboot [stack-unit] [members | 0-11]
To return to the default, use the no redundancy disable-auto-reboot
stack-unit
command.
Parameters
stack-unit Enter the stack-unit number. For the Z9000, the range is
from 0 to 7.
members This is all stack-units.
Defaults Disabled (the failed switch is automatically rebooted).
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1508
Stacking