Administrator Guide

----------------------
0/49 1/49
0/50
0/51 2/49
1/49 0/49
1/50 2/51
2/49 0/51
2/51 1/50
2/52
Dell#
Related
Commands
• reset stack-unit – resets the designated stack member.
• show hardware stack-unit – displays the data plane or management plane input
and output statistics of the designated component of the designated stack
member.
• show system (S-Series and Z-Series) – displays the current status of all stack
members or a specific member.
• upgrade (S-Series management unit and Z-Series) – upgrades the bootflash
image or system image of the S-Series management unit.
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Z9000
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identifier.
1–14 This preference parameter allows you to specify the
management priority of one backup switch over another,
with 0 the lowest priority and 14 the highest. The switch with
the highest priority value is chosen to become the
management unit if the active management unit fails or on
the next reload.
Defaults 0
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Stacking
1515