Administrator Guide

• show system (S-Series and Z-Series) – displays the status of all stack members
or a specific member.
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure
the unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-
id stack-group stack-id command.
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 15.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Reset command mode from EXEC to CONFIGURATION.
Version
8.3.10.2
Introduced on the S4810.
Usage
Information
The following message displays to confirm the command.
Setting ports Fo 0/60 as stack group will make their interface
configs obsolete after a reload.[confirm yes/no]: If “y” is
entered, all non-default configurations on any member ports of
the current stack group will be removed when the unit is
rebooted.
NOTE: Any scripts used to streamline the stacking configuration process must
be updated to reflect the Command Mode change from EXEC Privilege to
CONFIGURATION to allow the scripts to work correctly.
Stacking
1517