Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Instroduces on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the C-Series and S-Series.
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei enable – Make packets eligible for dropping based on their DEI value.
member
Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Z9000
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/ port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults Not configured.
Command
Modes
CONF-IF-VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
VLAN Stacking
1575