Administrator Guide

Usage
Information
In a square VLT topology with only one link connecting remote peers, if you
configure this command, any node has to send its VLT peer’s MAC address along
with its own MAC address to the remote VLT domain. By default, a node will send
only its own MAC address to the remote VLT domain. This parameter is applicable
for an LLDP proxy gateway configuration.
Example
Dell(conf-vlt-domain-proxy-gw-lldp)# vlt-peer-mac transmit
show vlt-proxy-gateway
Display the VLT proxy gateway configuration.
Z9000
Syntax
show vlt-proxy-gateway info {lldp | static}
Parameters
lldp Display details about the LLDP VLT proxy gateway
configuration
static Display details about the static VLT proxy gateway
configuration
Command
Modes
EXEC
EXEC Privilege
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
At any point of time the proxy-gateway feature may go operationally down for the
following reasons,
1) LLDP globally disabled
2) LLDP disabled per port
3) VLT port-channel is down
5) LLDP neighbor down
So, the proxy-gateway feature could be operationally down though properly
configured and this will be reported in the “show command”.
When more than one VLT port-channel terminates on the same TOR, output of the
show VLT proxy-gateway info lldp command may show the port-channel
id incorrectly.
1614
VLT Proxy Gateway