Administrator Guide

To delete an access list, use the no ip access-list standard access-
list-name command.
Parameters
access-list-
name
Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any,” that is, if no match occurs, the
packet is dropped.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
Version 6.5.1.0 Expanded to include the optional QoS order priority for the
ACL entry.
Usage
Information
Dell Networking OS supports one ingress and one egress IP ACL per interface.
Prior to Dell Networking OS version 7.8.1.0, names are up to 16 characters long.
The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
Example
Dell(conf)#ip access-list standard TestList
Dell(config-std-nacl)#
Related
Commands
ip access-list extended — creates an extended access list.
182
Access Control Lists (ACL)