Administrator Guide

Usage
Information
When you use the log option, the CP processor logs detail the packets that match.
Depending on how many packets match the log entry and at what rate, the CP
may become busy as it has to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
Related
Commands
permit — configures a MAC address filter to pass packets.
seq — configures a MAC address filter with a specified sequence number.
mac access-list standard
To configure a standard MAC ACL, name a new or existing MAC access control list (MAC ACL) and enter
MAC ACCESS LIST mode. Also refer to the Commands Common to all ACL Types section and the
Common MAC Access List Commands section.
Z9000
Syntax
mac access-list standard mac-list-name
To delete a MAC access list, use the no mac access-list standard mac-
list-name
command.
Parameters
mac-list-name Enter a text string as the name of the standard MAC access
list (140 character maximum).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
220
Access Control Lists (ACL)