Administrator Guide

• Use the no deny {any | host mac-address | mac-source-address
mac-source-address-mask} {any | host mac-address | mac-
destination-address mac-destination-address-mask} command.
Parameters
any Enter the keyword any to drop all packets.
host mac-
address
Enter the keyword host and then enter a MAC address to
drop packets with that host address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
mac-
destination-
address
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-
destination-
address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of
the following Ethertypes:
• ev2 - is the Ethernet II frame format
• llc - is the IEEE 802.3 frame format
• snap - is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the
packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface. For more information, refer to the “Flow-based
Monitoring” section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Defaults Not configured.
Access Control Lists (ACL)
225