Administrator Guide

Usage
Information
Sequence numbers for this filter are automatically assigned starting at sequence
number 5.
If you do not use the ge or le options, only packets with an exact match to the
prefix are filtered.
Related
Commands
deny — configures a filter to drop packets.
seq — configures a drop or permit filter with a specified sequence number.
seq
To a deny or permit filter in a prefix list while configuring the filter, assign a sequence number.
Z9000
Syntax
seq sequence-number {deny | permit} {any} | [ip-prefix /nn {ge
min-prefix-length} {le max-prefix-length}] | [bitmask number]
To delete a specific filter, use the no seq sequence-number {deny |
permit} {any} | [ip-prefix {ge min-prefix-length} {le max-
prefix-length}] | [bitmask number].
Parameters
sequence-
number
Enter a number. The range is from 1 to 4294967294.
deny Enter the keyword deny to configure a filter to drop packets
meeting this condition..
permit Enter the keyword permit to configure a filter to forward
packets meeting this condition.
any (OPTIONAL) Enter the keyword any to match any packets.
ip-prefix /nn (OPTIONAL) Specify an IP prefix in the network/length
format. For example, 35.0.0.0/8 means match the first 8 bits
of address 35.0.0.0.
ge min-prefix-
length
(OPTIONAL) Enter the keyword ge and then enter the
minimum prefix length, which is a number from zero (0) to
32.
le max-prefix-
length
(OPTIONAL) Enter the keyword le and then enter the
maximum prefix length, which is a number from zero (0) to
32.
bitmask
number
Enter the keyword bitmask then enter a bit mask number in
dotted decimal format.
Defaults Not configured.
236
Access Control Lists (ACL)