Administrator Guide

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match origin
To match routes based on the value found in the BGP path ORIGIN attribute, configure a filter.
Z9000
Syntax
match origin {egp | igp | incomplete}
To disable matching filter, use the no match origin {igp | egp |
incomplete}
command.
Parameters
egp Enter the keyword egp to match routes originating outside
the AS.
igp Enter the keyword igp to match routes originating within
the same AS.
incomplete Enter the keyword incomplete to match routes with
incomplete routing information.
Defaults Not configured.
Access Control Lists (ACL)
249