Administrator Guide

prompted for a sequence number if there are multiple
instances of the route map. The range is from 1 to 65535.
Defaults Not configured.
If you do not define a keyword (permit or deny) for the route map, the permit
action is the default.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
Use caution when you delete route maps because if you do not specify a sequence
number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
Related
Commands
show config — displays the current configuration.
set as-path
To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
Z9000
Syntax
set as-path prepend as-number [... as-number]
Access Control Lists (ACL)
253