Administrator Guide

pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag — computes the tag value of the route.
set level — specifies the OSPF area for route redistribution.
set metric — specifies the metric value assigned to redistributed routes.
set tag — specifies the tag assigned to redistributed routes.
set next-hop
To specify an IP address as the next hop, configure a filter.
Z9000
Syntax
set next-hop ip-address
To delete the setting, use the no set next-hop ip-address command.
Parameters
ip-address Specify an IP address in dotted decimal format.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
If you configure the set next-hop command, its configuration takes precedence
over the neighbor next-hop-self command in the ROUTER BGP mode.
262
Access Control Lists (ACL)