Administrator Guide

VlanHp : 1
VlanFcoe : 1
cam-acl-vlan
Allocate the number of flow processor (FP) blocks or entries for VLAN services and processes.
Syntax
cam-acl-vlan { default | vlanopenflow <0-2> | vlaniscsi <0-2> |
vlanaclopt <0-2>
Parameters
default Reset the number of FP blocks to default. By default, 0
groups are allocated for the ACL in VCAP. ACL VLAN groups
or CAM optimization is not enabled by default, and you need
to allocate the slices for CAM optimization.
vlanopenflow
<0-2>
Allocate the number of FP blocks for VLAN open flow
operations.
vlaniscsi <0-2> Allocate the number of FP blocks for VLAN iSCSI counters.
vlanaclopt
<0-2>
Allocate the number of FP blocks for the ACL VLAN
optimization feature.
Default If you use the default keyword with the cam-acl-vlan command, the FP blocks
allocated for VLAN processes are restored to their default values. No FP blocks or
dynamic VLAN Content Aware Processor (VCAP) groups are allocated for VLAN
operations by default.
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the S4810 and Z9000 platforms.
Usage
Information
The VLAN ContentAware Processor (VCAP) application is a pre-ingress CAP that
modifies the VLAN settings before packets are forwarded. To support the ACL CAM
optimization functionality, the CAM carving feature is enhanced. A total of four
VACP groups are present, of which two are for fixed groups and the other two are
for dynamic groups. Out of the total of two dynamic groups, you can allocate zero,
one, or two flow processor (FP) blocks to iSCSI Counters, OpenFlow and ACL
Optimization. You can configure only two of these features at a point in time.
Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)
321