Administrator Guide

Parameters
ipv4 multicast Enter the keyword ipv4 followed by the keyword
multicast to enable BGPv4 multicast mode.
ipv6 unicast Enter the keyword ipv6 followed by the keyword unicast
to enable BGPv6 mode.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 6.5.1.0 Introduced
aggregate-address
To minimize the number of entries in the routing table, summarize a range of prefixes.
Z9000
Syntax
aggregate-address ip-address mask [advertise-map map-name] [as-
set] [attribute-map map-name] [summary-only] [suppress-map map-
name]
Parameters
ip-address
mask
Enter the IP address and mask of the route to be the
aggregate address. Enter the IP address in dotted decimal
format (A.B.C.D) and mask in /prefix format (/x).
advertise-map
map-name
(OPTIONAL) Enter the keywords advertise-map then the
name of a configured route map to set filters for advertising
an aggregate route.
as-set
(OPTIONAL) Enter the keyword as-set to generate path
attribute information and include it in the aggregate.
AS_SET includes AS_PATH and community information from
the routes included in the aggregated route.
Border Gateway Protocol
345