Administrator Guide

bgp router-id
Assign a user-given ID to a BGP router.
Z9000
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address Enter an IP address in dotted decimal format to reset only
that BGP neighbor.
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the
router.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Peering sessions are reset when you change the router ID of a BGP router.
This command automatically restarts the BGP instance for the configuration to
take effect.
clear ip bgp
Reset BGP sessions. The soft parameter (BGP Soft Reconfiguration) clears the policies without resetting
the TCP connection.
Z9000
Syntax
clear ip bgp * | as-number | ip-address [flap-statistics | soft
[in | out]]
368
Border Gateway Protocol