Administrator Guide

Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
as-number Enter the AS number to reset all neighbors belonging to that
AS. The range is from 0 to 65535 (2 byte), from 1 to
4294967295 (4 byte), or from 0.1 to 65535.65535 (dotted
format).
ip-address Enter an IP address in dotted decimal format to reset all
prefixes from that neighbor.
flap-statistics (OPTIONAL) Enter the keyword flap-statistics to reset
the flap statistics on all prefixes from that neighbor.
soft (OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
NOTE: If you enter the clear ip bgp ip-address
soft command, both inbound and outbound policies
are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound
policies.
out (OPTIONAL) Enter the keyword out to activate only
outbound policies.
NOTE: You must execute the clear ip bgp soft
out
command when ever there is a change in the local
policy. If you do not run this command after a local
policy change, then these policy changes are not
reflected in the responses to the peer’s route refresh
messages.
<1-429496729
5>
Enter <1-4294967295> to clear peers with the AS number.
<0.1-65535.65
535>
Enter <0.1-65535.65535> to clear peers with the AS number
in dot format.
A.B.C.D Enter the BGP neighbor address in the A.B.C.D format to
clear.
X:X:X:X::X Enter the BGP neighbor address in the X:X:X:X::X format to
clear.
dampening Enter the keyword dampening to clear the flap dampening
information.
flap-statistics Enter the keywords flap-statistics to clear the flap
statistics information.
ipv4 Enter the ipv4 address family to clear.
ipv6 Enter the ipv6 address family to clear.
Border Gateway Protocol
369