Administrator Guide

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To view information on both incoming and outgoing routes, do not include the in
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter the debug ip bgp in command and
then enter the
debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
Related
Commands
debug ip bgp events — views information about BGP events.
debug ip bgp keepalives — views information about BGP keepalives.
debug ip bgp notifications — views information about BGP notifications.
debug ip bgp updates — views information about BGP updates.
show debugging — views enabled debugging operations.
debug ip bgp dampening
View information on routes being dampened.
Z9000
Syntax
debug ip bgp [vrf test | ipv4 {unicast | multicast} | ipv6
{unicast | multicast} dampening
To disable debugging, use the no debug ip bgp ipv4 multicast dampening
command.
Parameters
dampening Enter the keyword dampening to debug route flap
dampening information.
Command
Modes
EXEC Privilege
374
Border Gateway Protocol