Administrator Guide

Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor default-originate
Inject the default route to a BGP peer or neighbor.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} default-originate
[route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-
group-name
} default-originate command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
Enter the name of the peer group to set the default route of
all routers in that peer group.
route-map
map-name
(OPTIONAL) Enter the keyword route-map then the name
of a configured route map.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
If you apply a route map to a BGP peer or neighbor with the neighbor default-
originate command configured, the software does not apply the set filters in the
route map to that BGP peer or neighbor.
When you configure a route-map for a BGP peer or peer group with the neighbor
default-originate
command, the command checks for the existence of the
route in BGP RIB.
388
Border Gateway Protocol