Administrator Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor distribute-list
Distribute BGP information via an established prefix list.
Z-Series
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address |
peer-group-name} distribute-list prefix-list-name {in | out}
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to apply the distribute list
filter to all routers in the peer group.
prefix-list-
name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to
allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
390
Border Gateway Protocol