Administrator Guide

Example
Dell#show running-config bgp
!
router bgp 100
network 1.1.11.1/32
network 1.1.12.1/32
network 1.1.13.1/32
neighbor 10.1.1.2 remote-as 200
neighbor 10.1.1.2 no shutdown
Dell#
timers bgp
Adjust the BGP Keep Alive and Hold Time timers.
Z-Series
Syntax
timers bgp keepalive holdtime
To return to the default, use the no timers bgp command.
Parameters
keepalive Enter a number for the time interval, in seconds, between
keepalive messages sent to the neighbor routers. The range
is from 1 to 65535. The default is 60 seconds.
holdtime Enter a number for the time interval, in seconds, between
the last keepalive message and declaring the router dead.
The range is from 3 to 65535. The default is 180 seconds.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
454
Border Gateway Protocol