Administrator Guide

Command
Modes
ROUTE MAP (config-route-map)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
Usage
Information
Like standard communities, you can use extended communities in the route-map
to match the attribute.
Example
Dell(config-route-map)#match extcommunity Freedombird
Dell(config-route-map)#
permit
To add rules (permit) from the two types of extended communities, Route Origin (rt) or Site-of-Origin
(soo), use this feature.
Z-Series
Syntax
permit {rt | soo} {as4 ASN4:NN | ASN:NNNN | IPADDR:NN}
To change the rules, use the no permit {rt | soo} {as4 ASN4:NN |
ASN:NNNN | IPADDR:NN} command.
Parameters
rt Enter the keyword rt to designate a Route Origin
community.
soo Enter the keyword soo to designate a Site-of-Origin
community (also known as Route Origin).
as4 ASN4:NN Enter the keyword as4 then the 4-octet AS specific
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).
ASN:NNNN Enter the 2-octet AS specific extended community number
in the format ASN:NNNN (2-byte AS number:4-byte
community value).
IPADDR:NN Enter the IP address specific extended community in the
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte
community value).
Defaults Not configured.
462
Border Gateway Protocol