Administrator Guide

Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
When you enable this command, if a Policy Map containing classification rules (ACL
and/or dscp/ ip-precedence rules) is applied to more than one physical interface
on the same port pipe, only a single copy of the policy is written (only one FP entry
is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of
the number of interfaces. For more information, refer to the “IP Access
Control Lists”, “Prefix Lists”, and “Route-map” sections in the Dell Networking
OS Configuration Guide.
show cam-acl
Display the details of the CAM profiles on the chassis and all line cards.
Z9000
Syntax
show cam-acl
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example
( Default)
Dell#show cam-acl (Default)
-- Chassis Cam ACL --
Current Settings(in block sizes)
1 block = 128 entries
L2Acl : 6
Ipv4Acl : 4
Ipv6Acl : 0
Ipv4Qos : 2
L2Qos : 1
L2PT : 0
IpMacAcl : 0
VmanQos : 0
Content Addressable Memory (CAM)
481