Administrator Guide

online stack-unit
Place a stack unit in the online state.
Z9000
Syntax
online stack-unit number
Parameters
number Enter the stack-unit number. The Z9000 range is from 0 to
7.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an
automatic process. A warning message appears when the offline stack-unit
command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Buffer Tuning Commands
The following sections detail the buffer tuning commands.
WARNING: Altering the buffer allocations is a sensitive operation. Do not use any buffer tuning
commands without first contacting the Dell Networking Technical Assistance Center (TAC).
498
Debugging and Diagnostics