Administrator Guide

port-set 0–0 Enter the keywords port-set with a port-pipe number. The
range is from 0 or 3 for the Z9000..
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
The unit numbers given are internal port numbers. For a cross reference of the
internal and user port numbers, refer to the Z9000 Debugging and Diagnostics
chapter in the Dell Networking OS Configuration Guide for the Z9000 System.
show hardware layer3
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Z9000
Syntax
show hardware layer3 {acl | qos} stack-unit number port-set 0–0
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select
between ACL or QoS data.
stack-unit
number
Enter the keywords stack-unit then a number to select a
stack ID. The range is 0 to 7 for the Z9000.
port-set 0–0 Enter the keyword port-set with a port-pipe number. The
range is 0 to 1 for the Z9000.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Debugging and Diagnostics
503