Administrator Guide

Version 8.2.1.0 Introduced on the C-Series and S-Series.
hardware-address
For manual configurations, specify the client hardware address.
Z9000
Syntax
hardware-address address
Parameters
address Enter the hardware address of the client.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Z9000
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Dynamic Host Configuration Protocol (DHCP)
519