Administrator Guide

Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the
VRF to configure the name server to IP address mapping for
that VRF.
name Enter the name od the host to be associated with an IP
address.
ip-address Enter the IP address of the name server in dotted decimal
format.
Defaults None
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to create a mapping between a host name server and its IP
addresses for a specific VRF.
Example
Dell(conf)#ip host vrf jay dell 1.1.1.1
ip name-server
Configures the name server IP addresses for VRF. Using this command, you can configure up to a
maximum of six IP addresses per VRF.
Z9000
Syntax
ip name-server [vrf vrf-name] ip-address [ip-address2] [ip-
address3] [ip-address4] [ip-address5] [ip-address6]
To undo the name server ip address configuration for VRF, use the no ip name-
server [vrf vrf-name]
ip-address command.
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the
VRF to configure the name server IP addresses for that VRF.
Dynamic Host Configuration Protocol (DHCP)
529