Administrator Guide

vlan-id vlan-id Enter the keywords vlan-id then the VLAN to which the
host belongs. The range is from 2 to 4094.
ip ip-address Enter the keyword ip then the IP address that the server is
leasing.
interface type Enter the keyword interface then the type of interface to
which the host is connected:
• For an 10/100 Ethernet interface, enter the keyword
fastethernet.
• For a Gigabit Ethernet interface, enter the keyword
gigabitethernet.
• For a Ten-Gigabit Ethernet interface, enter the keyword
tengigabitethernet.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE.
slot/port Enter the slot and port number of the interface.
lease time Enter the keyword lease then the amount of time the IP
address are leased. The range is from 1 to 4294967295.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Related
Commands
show ip dhcp snooping — displays the contents of the DHCP binding table.
Dynamic Host Configuration Protocol (DHCP)
535