Administrator Guide

Command
Modes
INTERFACE
INTERFACE PORTCHANNEL
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.6(0.0) Added the keyword vlan and the variable vlan-id.
Introduced support for SAV on port channels.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the E-Series.
Version 8.2.1.0 Added the keyword ipmac.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Usage
Information
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source
Address Validation and SAV with VLAN option.
1. Use the cam-acl l2acl command from CONFIGURATION mode.
2. Save the running-config to the startup-config.
3. Reload the system.
ip dhcp snooping vlan
Enable DHCP Snooping on one or more VLANs.
Z-Series
Syntax
[no] ip dhcp snooping vlan name
Parameters
name Enter the name of a VLAN on which to enable DHCP
Snooping.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
538
Dynamic Host Configuration Protocol (DHCP)