Administrator Guide

PORT-CHANNEL FAILOVER-GROUP Mode
To configure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more
information, refer to Port Channel Commands.
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the port-channel failover-group command. The prompt changes to include (conf-po-
failover-grp).
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip prefix-list command. Include a name for the prefix list. The prompt changes to
include (conf-nprefixl).
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For
more information, refer to GARP VLAN Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol gvrp command. The prompt changes to include (config-gvrp).
You can return to CONFIGURATION mode by using the exit command.
RAPID SPANNING TREE (RSTP) Mode
To enable and configure RSTP, use RSTP mode. For more information, refer to Rapid Spanning Tree
Protocol (RSTP).
To enter RSTP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol spanning-tree rstp command. The prompt changes to include (conf-rstp).
You can return to CONFIGURATION mode by using the exit command.
ROUTE-MAP Mode
To configure a route map, use ROUTE-MAP mode.
To enter ROUTE-MAP mode:
1. Verify that you are logged in to CONFIGURATION mode.
CLI Basics
55