Administrator Guide

invalid value is entered, an error message is generated. The
range is from 50 to 2000 ms. Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in
milliseconds, to set the dead interval of the control packets.
The range is from 50 to 6000 ms. Default: 1500 ms.
NOTE: The configured dead interval must be at least
three times the hello interval.
Defaults
• 500 ms for hello-interval milliseconds
• 1500 ms for dead-intervalmilliseconds
Command
Modes
CONFIGURATION (conf-frrp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
Usage
Information
The hello interval command is the interval at which ring frames are generated
from the primary interface of the master node. The
dead interval command is
the time that elapses before a time-out occurs.
Force10 Resilient Ring Protocol (FRRP)
575