Administrator Guide

Parameters
join Enter the keyword join then the number of milliseconds to
configure the join time. The range is from 100 to 147483647
milliseconds. The default is
200 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave Enter the keyword leave then the number of milliseconds
to configure the leave time. The range is from 100 to
2147483647 milliseconds. The default is
600 milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
leave-all Enter the keywords leave-all then the number of
milliseconds to configure the leave-all time. The range is
from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE: Designate the milliseconds in multiples of 100.
Defaults As above.
Command
Modes
CONFIGURATION-GVRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Usage
Information
• Join Timer — Join messages announce the willingness to register some
attributes with other participants. For reliability, each GARP application entity
sends a
Join message twice and uses a join timer to set the sending interval.
• Leave Timer — Leave announces the willingness to de-register with other
participants. Together with Join, Leave messages help GARP participants
complete attribute reregistration and de-registration. The leave timer starts after
receipt of a leave message sent for de-registering some attribute information. If
a
Join message is not received before the Leave time expires, the GARP
application entity removes the attribute information as requested.
• Leave All Timer — The Leave All timer starts when a GARP application entity
starts. When this timer expires, the entity sends a Leave-all message so that
other entities can reregister their attribute information. Then the Leave-all
time begins again.
580
GARP VLAN Registration (GVRP)