Administrator Guide

ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
Z9000
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Defaults 60 seconds
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
Version 7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
Internet Group Management Protocol (IGMP)
601