Administrator Guide

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.4.1.0 Introduced
Usage
Information
This command applies to any physical interface with speed set to 10/100.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to 10 Mbps or 100 Mbps, you can also execute the duplex
command.
Related
Commands
negotiation auto — enables or disables auto-negotiation on an interface.
flowcontrol
Control how the system responds to and generates 802.3x pause frames on 10 Gig and 40 Gig ports.
Z9000
Syntax
flowcontrol rx {off | on} tx {off | on}
Parameters
rx on Enter the keywords rx on to process the received flow
control frames on this port. This is the default value for the
receive side.
rx off Enter the keywords rx off to ignore the received flow
control frames on this port.
tx on Enter the keywords tx on to send control frames from this
port to the connected device when a higher rate of traffic is
received.
tx off Enter the keywords tx off so that flow control frames are
not sent from this port to the connected device when a
higher rate of traffic is received.
Parameters
Defaults Z9000: rx off tx off
Command
Modes
INTERFACE
Interfaces
625