Administrator Guide

show range — shows the bulk configuration ranges.
interface range macro (define) — defines a macro for an interface-range.
interface range macro (define)
Defines a macro for an interface range and then saves the macro in the running configuration.
Z9000
Syntax
define interface range macro name interface , interface , ...
Parameters
name Enter up to 16 characters for the macro name.
interface,
interface,...
Enter the keywords interface range and one of the
interfaces — slot/port, port-channel, or VLAN number. Select
the range of interfaces for bulk configuration. You can enter
up to six comma-separated ranges. Spaces are not required
between the commas. Comma-separated ranges can
include VLANs, port-channels, and physical interfaces.
Slot/Port information must contain a space before and after
the dash. For example, interface range
gigabitethernet 0/1 - 5 is valid; interface range
gigabitethernet 0/1-5 is NOT valid.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Interfaces
637